 |
|
Group the pieces and
plastic bags containing the screws as shown in the group photos.
For each
group of pieces remove the screws from the bag and start the screws
into the countersunk holes on the pieces. Advance the screws into
the hole until they protrude slightly from the other side.
The protruding screw will help you line up pieces when assembling. |
 |
|
Notice that the seat
slats are numbered on the underside of each slat - align these in
order as shown at left.
After all the screws are started
on all pieces, you are ready to assemble. Follow the sequence on
the next page. |
Important:
Make sure the pieces being attached to each other are pressed
against each other with no gap in between and that the screws are
lined up to the predrilled holes. Do not overtighten the screws.
When using a drill, advance the screw most of the way and then final
tighten by hand until snug. |
 |
|
 |
 |
|
 |
 |
|
 |
Step 6:
start with the middle piece and work toward the outsides.
Steps
7&8: the slats are numbered underneath. Attach #0, then
attach the shorter slats #7&8. This will make it easier to line
up the holes for the other slats. |
 |
|
 |
 |
|
Your
chairs are
ready to enjoy!!! |
